How To Use Bias Tape Maker

Push the fabric strip through the large end of the bias maker all the way through the other end the smaller end Slightly pull it out with your hand just enough for you to be able to see that its forming into bias tape.
How to use bias tape maker. How to Use a Bias Tape Maker First you must decide whether you need single or double fold tape. Select the appropriate sized bias tape maker based on the finished width desired. Press the tape as you go.
How to use a bias tape maker a gadget designed to turn bias strips into bias tape. For the 50 tool the strips should be 3 78 wide. If you cut a 2 wide binding you will insert it into the 25mm bias tape maker it will come out 1 wide and then you will fold it in half again when you.
Cut out your bias tape to the length as indicated on your pattern. If the fabric is cut along one of the two straight of grain directions on the fabric either parallel or perpendicular to the selvage you will get straight grain tape. I highly suggest NOT dragging the iron but picking it up and placing it back down.
This can either be indicated by a pattern you are following or indicated on the bias tape maker package. Pull just a little bit out of the end to get it started. Make sure the seam stays on the top in the middle.
I place the iron on the first bit of bias tape right up to the maker. It works great for finishing underarms or making hems. SINGLE-FOLD bias tape has been folded in once on each edge toward the center on the wrong side.
Then gently coax the strip out the narrow end of the tape maker and youll see that the fabric is being folded as it passes through the tape maker. Mark this number on your bias tape maker with a piece of tape or a fancy label so youll remember each time you use it. This will make feeding if through the bias tape maker a lot easier.