How To Put On A Belt Buckle

How to take your own picturesdesigns and put them into a rad belt buckleTools youll needCasting ResinCatalystClear tapeScissorsMixing bowl.

How to put on a belt buckle. This will help you make sure that the buckle is facing in the right direction. Attach the looped fabric with the screw using a flat-head screwdriver and a pair of adjustable pliers. Take the first keeper and slide it over the right side of the belt strap about 6 inches.

Time to put the buckle on. Before riveting it is necessary to puncture a hole or slit through which the metal clip of. Depending on your belt and buckle you now want to unsnap the snaps that are at the end of the belt if you want to push the studs through their holes.

Put the end of the belt without rings through the belt loops or around the waist starting at the left hip and ending with the rings on the left and ring-less end on the right. Accessorizing your custom leather belts with an attention grabbing buckle may be a good way to face out from the gang. A keeper is a flat piece of metal or brass that has a rectangular hole in the center allowing the belt strap to slide through.

You can then reverse the belt by passing it over the first loop and then under the second loop interchangeably. After screwing the tab into place over the metal loop your cowboy belt buckle will be complete. Then take the end of the belt and push it through the frame of the buckle.

These studs or snaps will be on the inside end of the belt that is folded back. If your belt has snaps or studs youll find these on the inside. Push the studs through the holes or unsnap the snaps at the end of the belt freeing up the end of the belt.

There are thousands of choices out there that it. Make sure youve got the buckle the right way. Attach the buckle to the belt.